Higher Performance
RTCA Training Center
RTCA offers training courses on documents to facilitate the use of key documents by our stakeholders, and to enhance the understanding of developing and using global standards and guidance. As a non-profit organization, RTCA is eager to assist the aviation community in implementing the new standards developed with by our special committees. For additional questions, please email training@rtca.org .

Current Training Courses

DO-160G Training 

RTCA, Inc. has teamed with Wichita State University’s National Institute for Aviation Research (WSU-NIAR) to offer high quality training covering RTCA's DO-160G, Environmental Conditions and Test Procedures for Airborne Equipment. The course will provide an understanding of the use of DO-160G and how it fits in with the greater picture of requirements, design, certification and Technical Standard Orders (TSOs). 

  • April 9-12, 2018 at RTCA
  • October 1-4, 2018 at WSU
  • December 11-14, 2018 at RTCA

DO-178C Training: Software Considerations in Airborne Systems and Equipment Certification

RTCA, Inc. has teamed with The MITRE Aviation Institute to offer “Software Considerations in Airborne Systems and Equipment Certification: DO-178C Training.” This three-day training course provides attendees with an in-depth understanding of the requirements and parameters for avionics software development necessary to obtain FAA certification. 

  • April 2-4, 2018
  • June 26-28, 2018
  • September 10-12, 2018
  • December 11-13, 2018

Supplements to DO-178C Training

Responding to the needs of the aviation community for additional training on the techniques needed to comply with DO-178C, Software Considerations in Airborne Systems and Equipment Certification, RTCA, Inc. offers a course that provides the background and scope on the four supplements supporting DO-178C: DO-330, DO-331, DO-332, DO-333.

  • April 5, 2018
  • June 29, 2018
  • September 13, 2018
  • December 14, 2018

DO-254 Training: Design Assurance Guidance for Airborne Electronic Hardware

RTCA is hosting a three-day training course, tailored specifically to design/verification engineers and project/certification managers requiring DO-254 compliance.

  • April 2-4, 2018
  • September 10-12, 2018
  • December 3-5, 2018

 

Upcoming Training Opportunities

*NEW* RFP for Training Course on RTCA Airworthiness Security

 

For additional questions, please email training@rtca.org .